SimScale simulation projects by ckramer | Page 1

ckramer's profile

Scaled elements to 1.25x. Hopefully makes big downforce.

Absolutely DESTROYED that notch, HE GONE, GONE!!!!!!!

No distinguishable inlet, diffuser slot. Massive diffusers... probably too big lol

Increased clearance to rear suspension arms

Running full aero on last years car to determine the effect of the front wing on the rear wing

Testing without top element. Expecting lower drag and downforce.

Testing basic rear wing, and will iterate until its actually good

moved elements as far vertically as possible

Straightened main tunnel, added a second tunnel.

Added cut in divider, and got rid of side diffuser curve

Smaller inlets, higher ground clearance, and gurney flaps on diffuser exit.

Smaller inlet, combined with center inlet

First iteration, basically an flipped design of the old one

Testing rotating domains, because I have no clue how to do it.

Halved inlet size, hopefully to reduce front lift

Rear wing with no leading edge flap, theres nothing more to it

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

ckramer's profile

Forum Activity