SimScale simulation projects by appeehal | Page 1

appeehal's profile

calculating the change in velocity of a diverging nozzle

Tutorial project for a thermal analysis of a differential casing. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

To see the effect of a choke point in a fluid flow

I will try to simulate the temperature increase in a gas piston compressor

This should check to see if the throttle turns CO2 from a liquid into a gas

This is the final test for the compressor (incompressible fluid) to test the software

This tutorial project aims to showcase how to set up and run a simulation for a pump geometry. The Standard meshing tool was used.

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Now I have inputted the flow volume into the actual cad as I drew it up

Now I have ungrouped the impeller comoponents

Test the compressor with the incompressible fluid simulation

Trying to get internal flow volume sorted

This is a primary run to test the software before the real test to make sure it will work.

LED Spotlight project, aiming a bring the temperature of the diodes of a LED spotlight design below the maximum allowed temperature of 100C. A Conjugate Heat Transfer v2.0 analysis is used.

Public Profile

appeehal's profile

Forum Activity