SimScale CAE Forum

Project Support


Guideline to asking for help with a project (3)

When asking for help on a specific project, please include the below points so that we can help you as quickly as possible; Include a link to your project (make sure that it is set to public) Complete as much of yo…

Inflate boundary layer induced illegal faces (6)
Drag Coefficient too high (11)
Problem with Surface refinement with Cell Zone (10)
Basic electronic cooling doesn't work (7)
Maximum Number of Iterations: CHT (3)
Solution Diverged - Bad Elements (5)
CFD analysis (15)
CFD Simulation Wooden Car (3)
Help on a simulation of forced convection on a battery pack (2)
Ahmed Body Drag Validation Problem ( 2 3 ) (48)
CFD Results (7)
Sheet Body Detected (2)
Wall distance experience, do these calculations look right? (y+ yPlus) (9)
Problem to inner region (4)
Help for the best BC for the case (3)
FOAM Fatal IO Error- CFD wing test (5)
Buried pipe heat transfer analysis (2)
Weird result of wing simulation (4)
Exceeded CFL (2)
Conduction,Convection,Radiation analysis (9)
No contacts were defined for some sub-assemblies (3)
Peltier cooling simulation in CFD (10)
Unwanted face splitting (15)
Enclosure and simulation (2)
Simulation run failure (2)
Contra-Rotating Windmill Simulation (6)
A multi-region mesh was assigned - this analysis-type requires a single-region mesh (12)
Use Larger Machine Error (6)
Problem in mesh (4)