Good evening Forum I have a project, that I am working on, it’s a so called hushbox, a box with a projector in it and internal fans for the cooling. Now the actual design I currently have is flawed, the projector gets too hot and I wanted to simulate some ideas for improvement. There is an inlet …

Hi! The project currently doesn’t contain a complete simulation setup, so it’s difficult to know for sure what the settings were. However, from your description, it feels like you were defining boundary conditions to contact faces (which is forbidden, i.e. this page ). If you’re looking to set inte…

Ventilation through fans inside a Box with openings

Project Support

Maverick2805 January 3, 2022, 10:26pm 4

Thank you for your Tipp Ricardo! I’ll read about this momentum Source, sounds quite about what I need.
I’ll try this tomorrow and will share my experience.

Thanks and good evening
Mav