Thermal Comfort In a Meeting Room

Project Support
1

Hi !
I tried to follow the advanced tutorial about Thermal Comfort In a Meeting Room.
The tutorial link : Thermal Comfort In a Meeting Room | Tutorial | SimScale

I followed all the steps, however when I launch the simulation after about 30 minutes the simulation stops. And I get this message:
image

Could someone please help me?

2

Hi @39001194,

Thanks for posting your question!
From the meshing log, we see that your mesh is not enough for the simulation so could you please post here your project link? Just to find where the problem is.

best,

3

Hi !

You can find here the link of the project.

Thanks

4

Hi @39001194,

Sorry for the delay. Please set the “Small feature suppression” parameter in the mesh settings as 0.004, run the mesh again, and then run the simulation again, it should be working well.

best,