Hi I am trying to perform FEA on a solar panel. Basically I am trying to assign material to the structures. I want to select galvanised iron for its structure but I am unable to select it. I only have the option of iron. Can anyone help me how can I change the material properties of iron to galvanis…

In your case I used HEX mesh as it was easier to me to control the mesh fineness and limit overall cells count (by applying region refinement near the geometry and keeping cells big in far field). One can now use TET mesh, by defining an enclosure, but a lot of different setups should be used to a…

ok @BenLewis thanks alot for your help

Ok now the thing is that I want basically want to publish a research paper in which I am thinking of doing comparitive analysis between I beams and C-channels according to the structure which I had designed and the discussions I have been doing with you guys since a long time. What I desire to show…

Hi @alijalil , I admire your enthusiasm for this project, but unfortunately I do not think your research topic is sufficiently novel. Any recognised steel design code would be substantially more rigorous than the analysis you have performed here. The pros and cons of I-beams and C-channels is gener…

oh okay @BenLewis yes you are absolutely right. However , can you suggest any modifications which I can make in this project to bring novelity in it. Or could you share any link where I can get help with regards to the publishing of a research paper ? Thats completely fine if you wont be able to …

Hi @alijalil , I cannot offer any advice with regards to research papers. You may find the resources you need through your local university.

@Retsam one more thing I would like to ask was that the CFD analysis which you did for my project was based on a wind angle of attack of 180 degrees right ? I would also like to ask that if I wish to change my angle of attack , how would I be able to incorporate that effect in my CFD analysis ? I me…

@BenLewis one more thing that I wanted to ask was that would we have to add welded joints between the I beams while performing FEA ?

Hi @alijalil , For different flow angles, you need to do the following: For changing the wind direction from Front to Rear, you need to rotate your geometry by 180 degree (as an example) . That rotation should be done in your CAD program. You need to import again the geometry into SimScale and recr…

Hi @alijalil , I’m SimScale you can assess the weld strength by modelling the weld geometry. The means separating the members by a small amount and joining them only at the weld interfaces. This can be a time consuming job, so you want to avoid it if possible. Here are some points to keep in mind: …

SimScale CAE Forum

Solar panel

Project Support

alijalil October 29, 2020, 4:48am 90

ok no issues @BenLewis. thanks alot