what to do with this error message
Multiple boundary condition assignments for the following entities: face240@Flow region
what to do with this error message
Multiple boundary condition assignments for the following entities: face240@Flow region
Greetings,
Could you please post your project link as well, so we can have a look?
On a general note, each face can only receive a single boundary condition, otherwise you will receive an error message like this one.
With that being said, the message is quite straightforward: make sure to review your boundary conditions, because this face must have been assigned to more than one .
Cheers
It means that you need to verify your BC assignments, as mistake is from that part of simulation preparation.
Take care,
Retsam