SimScale CAE Forum

Sheet Metal Stamping


#1

This week’s Project Spotlight is a sheet metal stamping process done by my colleague @rszoeke.

Two different meshes were created for the quarter symmetric stamp model, one with full tet-meshing and the other with mixed meshing with tet- and hex-cells. Initially the results were compared for the same contact parameters using the penalty contact method.

Further analysis was done on the mixed mesh using a Lagrangian contact solution. Elastic Support was used to prevent rigid body motions of the sheet metal after stamping.

>>>Click here to view the project


\underline{\textbf{Visit our SimWiki by clicking on the picture}}


Community Digest July 2016