Hi everyone,
I have a heat transfer project with exhaust fan, how to setup the proper mesh refinement for this project?
I tried many times, always had problems on it.
any suggestions?
Thanks!
here’s my project link
Conjugate with rotating zone
Hello Hwibowo,
When setting up rotating zones you can use this document as a guide. It should provide the necessary information needed to properly setup and run a simulation using an MRF zone. Let me know what you think.
Best,
Jake
1 Like
Hi Jake, thank u so much for responding. ok I’ll do it
although it wasn’t me asking, huge thanks for this guide. i find it really helpful
1 Like
Awesome to hear! I am happy to provide some useful information when needed! If you have any specific questions shoot me a message or write up a forum post for longer questions!
Best,
Jake