Hi! I am trying to replicate the following exercise: [image] Turbulent Flow Through Pipe | Validation Case | SimScale This SimScale validation case assesses incompressible steady-state turbulent models applied to water flow through a straight pipe. Est. reading time: 5 minutes …

how can i check the y+ without using Paraview? Just using the postprocessing on the cloud Thanks

First you have to create a field calculation of y plus in the result control. As shown below. [y%20plus] Then you can see the y plus result in the Post processor. As shown below. [y] Regards

I have already done that as you can see on my pictures in previous posts. So, why the y+ obtained in those pictures are different compared with the validation case if the model used is the same? thanks!

Your model is not the same as in the validation case, your model have different dimensions, So there should be different mesh and B.L settings to obtain the same result.

I know that my model has different measures and different data so it doesnt make sense to compare them. As i told you and as you can see in the pictures, I am using a copy of the model of the validation case. (it is not my model). This is my unique way to ensure that the y+ figured on the document…

SimScale Login Log in to your SimScale account. SimScale makes high-fidelity engineering simulation technically and economically accessible. At any scale. In the cloud.

This one is different from your previous project, you have copied it.

I am going to start to explain again cause i think you dont understand me. My project is similar but different in some aspects of the one which there is on the documentation. I tried first at the beginning based on it but i couldnt find a proper mesh with a proper y+. So, at the moment i am tryin…

I need the project link originally created by you, if you have created one for this purpose.

SimScale CAE Forum

MESHING turbulent pipe flow

Project Support

HamzaBaig September 25, 2019, 2:47pm 23

Please share the project link.