Subsonic

Find projects using the subsonic analysis type here. | Page 1

Steady state and transient analysis of an industrial 7 blade fan ducted fan assembly with cowling.

Assessment of the water level of a cooling tower water distribution open channel.

The channel has a water inlet and numerous holes for outlet, while it is open to the atmosphere.

Three different designs are evaluated to optimize the filling performance. Watch our on-demand webinar about Multiphase capabilities where this case is presented in more detail
https://www.simscale.com/webinars-workshops/new-multiphase-flow-capabilities/

In this project, a thermal shock & flow analysis of a globe valve is performed. Multiphase (Air/Water) & Single phase flow is modeled.

Industrial mixing tank example using the Multiphase solver.

In this example, a simple tank and a baffled tank design are compared in terms of mixing performance. The simulation involves 2-phases (air/water) and rotating parts (impellers).

As a final step, a sparger is implemented at the bottom of the tank, to simulate the tank aeration process.

This example is part of our free on-demand Multiphase webinar. Please register via the following link to watch how this case was setup inside the SimScale platform.
https://www.simscale.com/webinars-workshops/new-multiphase-flow-capabilities/

In this project, a multiphase flow analysis of a globe valve is performed.

In response to 
https://www.cfd-online.com/Forums/main/248336-unexpected-velocity-profiles-pipe-flow-elbows.html

Standard WSD unit with elongated outlet pipe. Short inlet pipe fed by cistern

This project demonstrates the flow of liquid water flowing through a heat-exchanger. The purpose of this simulation is to analyse the flow distribution and check if there are air locks created.

Alternative designs for the WSD - Based on research paper for good siphon performance.

Validation of the performance of a centrifugal pump with the Subsonic analysis type, automatic pump curve generation and transient analysis.

This tutorial teaches how to run a transient incompressible flow simulation using the Subsonic analysis type in SimScale using the AMI rotating zone on a Francis turbine.

Transient analysis of external aerodynamics of quadcopter drone

3D Printed Centrifugal Pump, as seen on grabcad: https://grabcad.com/library/3d-printed-centrifugal-pump-1

This is a demonstration case for real gas feature

Evaluate the performance of 3 different axial fan designs and seamlessy extract fan efficiency curves.

Quickly perform RPM sweeps to evaluate the axial fan model under different operating conditions

Uses a bell siphon like design with reference to the research paper

Part of my thesis on cooling channel layouts

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation. - Copy

This tutorial project aims to showcase how to set up and run a simulation for a pump geometry. The subsonic meshing tool was used with coarse meshing. - Copy

This tutorial project aims to showcase how to set up and run a simulation for a pump geometry. The Standard meshing tool was used.

Subsonic multiphase project on oil filter from Jon

The results of this SimScale validation case of a centrifugal pump are compared with the results of the study by WANG Xiu-yong and WANG Can-xing entitled Performance Prediction of Centrifugal Pump Based on the Method of Numerical Simulation.

The SimScale subsonic solver was used.

This project simulates laminar flow through a straight circular pipe.

Subsonic | SimScale Project Library | Page 1