I have been trying to run FEA simulation on an active aero wing design of a car. I have directly imported the CAD from Onshape. I know that its slightly poor but I have no other option but to use the same design.
Whenever I click on simulations, it throws two errors ( I have attached my project link) about some connectors not connected or about some part not being detected.
I am trying to solve this problem from a long time now, so I would really appreciate your input or assistance.
Thank you
https://www.simscale.com/workbench/?pid=4547104841922103757&location=simulation:cd58dd3d-695d-4ea7-9214-6cd8ea34fb44&ps=analysis%2Fconnectors%2F0
Hi,
The current pin connector settings look extremely weird, I’d strongly suggest reviewing this page: https://www.simscale.com/docs/simulation-setup/connectors/
Side note: if all CAD parts are bonded and they’re made of the same material, you can just boolean/union everything into a single part. Of course you have to make sure that all parts are actually touching for the union operation to merge them.
