The specified runtime was exceeded

Using SimScale
1

Dear Sir/Madam,

We are in the middle of simulation on NACA 2412 airfoil but somehow using K-ω SST trying also a better refinement, we receive a message ,which stops the creation, “the specified runtime exceeded”.

Could you please assist on that? This is our first project as students and our experience is limited.

Thank you in advance

2

Hi!

I assume you ran into maximum runtime issues when running a simulation? If that’s the case, consider raising the value for the maximum runtime under the Simulation control settings:

image
image815×516 26.6 KB

For community plans, you can run with a maximum runtime of up to 30000 seconds.

Cheers

1 Like