Hi, I would like to ask the forum if there is any way to restart a new run of the same case but starting from the latest time calculated on a previous run. For those familiar with OpenFOAM, it should be something similar to set the ‘startFrom’ keyword to ‘latestTime’ on the ‘controlDict’ dictionary…

Hi @jrodrig : You can use finished simulation and click on ‘>>’ button. After that you define for how long you wish to continue your simulation. If not enough, you can add another simulation sequence. [image] Take care, Retsam

Hi @Retsam , thanks for your reply. I am doing a transient multiphase analysis. I don’t seem to find that button. I read somewhere that that feature only applies to steady-state analysis. Am I right? Thanks jose

[image] jrodrig: I read somewhere that that feature only applies to steady-state analysis. Am I right? If it was stated somewhere, I will bet on it. Thanks, Retsam

SimScale CAE Forum

Start from previous run (latestTime)

Using SimScale

Retsam August 9, 2020, 8:16pm 4

If it was stated somewhere, I will bet on it.

Thanks,

Retsam