Hello, i am using the drone arm sample. The load at the end of the arm is 10N. Simulation and post processing went well. Now i changed the load to 100N, defined a new simulation run. The run went well. But: the result in post processing are exactly the same compared to those of run 1. I definite…

Hello @wmay , to me it looks like the results are perfectly fine. The stresses of the 100N load are exactly 10 times as high as the 10N load case: [image] 100N Load case [image] 10N load case Maybe you selected two times the same result, or you missed the e+7 instead of e+6 in the stress scal…

Hello Richard, you are right, i missed e+7. Carefully reading is the best option :slight_smile: kindly regards Wolfgang

SimScale CAE Forum

Several runs with several loads - same result?

Using SimScale Solid Mechanics / FEA

wmay December 30, 2016, 8:58pm 3

Hello Richard,

you are right, i missed e+7.
Carefully reading is the best option

kindly regards
Wolfgang