Post-Processor - Visualization Help

[Get_Barried]

Hi @schrist,

@schrist

how do I add filters to add things such as Stream tracer ?

You’ll have to look through the new post-processor documentation for that. Haven’t had the chance to use it myself . Maybe Jousef can advise you.

@schrist

Also how do I identify the x, y, z coords for setting probe points is there any identify type of tool I can use or visual selection that identifies these?

Unfortunately, you’ll have to know these coords from the CAD itself. However, a small workaround (despite being very inelegant) is to use the material point itself to deduce the zero point and extrapolate roughly where the points of interest are. Of course, if you want to be super accurate, a CAD software is a must.

Cheers.

Regards,
Barry