Hi, I’m running some CFD simulations on a simple case study for an university course and I’m having trouble using SimScale post-processor. The problem I’m facing is that either the countours change after a while (see attached screenshots) or it doesn’t even work from the beginning, showing an almos…

Hi @nfranzoi : Please disregard ‘Time 0’, as it means simulation did not run yet. For pressure graphs you need to scale better, I think, but you should expect low pressure where you have high velocity: without project it is not obvious to diagnose from your pictures. Cheers, Retsam

Hi @nfranzoi ! Thanks for reporting this - will forward this to my colleagues from the engineering team and we will get back to you as soon as possible. Sorry for the lost productivity! Keeping you up-to-date! Jousef

Hi @Retsam , Shame on me! The time must have rewound without me noticing and the other times the post-processor opened the result at the initial time rather than at the final (I’m running steady state simulation so I guess time refers to the iteration step, am I wrong?). By clicking on the last fram…