Hi everyone, I am currently trying to post-process in ParaView for a project I did here in SimScale. When I go to plot Cp vs the distance along the chord length of my airfoil. I get this … [39] What could be the possible cause of this? [21] I know I am being quite vague but I don’t know exact …

Hey @pamelatreacy11 , can you post a link to your simulation, and further information which simulation is your plot about ? Best regards Kai

Hi Kai, Yes of course. My simulation link is: https://www.simscale.com/workbench/?pid=8358583334176883640&rru=3b68d092-4955-4d43-a17f-ca908f2ae283&ci=a3a6b064-57d1-4166-9a0b-4b04f67f2483&ct=PLOT&mt=SIMULATION_RESULT . I am look at Run 3 for AOA 1.98. Thanks, Pamela

Hi Kai, Have you had any insight into what has gone wrong? Thanks, Pamela

Hey Pamela, not till now, sorry. Which Surface do you extract and how do you use the calculator ? Sorry, when i first looked at it, i missed the paraview filters. If you can save the state, and upload it, we can directly open it up in paraview. [grafik] Best regards Kai

Hi Kai, No problem. I tried uploading but I am unable to as it says that the extension type is not aloud only jpeg,png etc are authorised. I got it into data points and it looks better but I’m not sure why the coefficient of pressures are so low. Its a NACA0012 airfoil at 6.22 AOA. [46] Could …

[03] My calculator is as above.

Hey @pamelatreacy11 , so i tried to recreat it. Here is my state file WeTransfer . Is the slice position correct ? Best regards Kai

Unfortunately this is the message I got when trying to load the state… [26] In term of the placement of the slice, either at the symmetry boundary or the open ended side of the airfoil is where I’m trying to extract data from. Thanks, Pamela

oh, ok. So i made it, like in the screenshot. How you plot the data, in my case, it plots the spreadsheet without an location reference… ? [Naca] Best regards Kai

SimScale CAE Forum

ParaView Help

Project Support

pamelatreacy11 April 7, 2020, 4:27pm 11

The distance along the chord can be put in place using x array name : points_x

1 Like