I don’t know what went wrong with my simulation, there are a few things I needed like the actual data, the pressure exerted on the mesh was far more than I wanted, and the simulation itself caused the mesh to go through itself. The mesh log appears to be fine so I don’t know what went wrong. …

There are quite a handful of runs in the project but the first one I saw with linear elastic materials had a Young’s modulus of 1e6 Pa (which is fairly small) and a Poisson’s ratio of 0.47 (i.e. close to incompressibility). I know this is some sort of tissue that you’re working with, but these prope…

Hi, When this happens, it is usually related to issues with material properties, boundary conditions (e.g. wrong units somewhere) or overconstrained models. I see that you’re using a hyperelastic material in this project. Where did the properties come from? For testing purposes, have you already t…

Thank you for the response, My hyper elastic material was my other attempt because initially I did a linear analysis, and the issue occurred, so i switched to a non-linear and now I still have issues. I am using a composite material I came up with the would mimic the heart so that is why I changed …

SimScale CAE Forum

Issues with post process results

Project Support

igaviano Split this topic January 28, 2025, 10:30pm 5

A post was split to a new topic: Issues with post process results