Hello, I am trying to simulate our front wing but I am getting an error message while meshing as: “The meshing algorithm failed with a floating-point exception” I have read posts regarding this but mostly all of them refer to this error faced during simulation whilst I am facing this error in mes…

Hi, If you have a look at the meshing log of the operation, you will notice a huge number of cells in error. [image] It is definitely not normal for a mesh to have this huge quantity of poor cells, which indicates issues somewhere else in the setup. One common issue that I see is when the boundi…

Hi there, have you checked the following page regarding this issue? [image] Most Popular Errors of Simulation Using SimScale Hi @Igarizza this is a very interesting question and I have been affected by this many times myself. I decided to write down some of my personal e…

Hi @tsite , As mentioned earlier, I have read this post and double-checked my initial conditions also. The post suggests changes that I guess would affect the simulation and not meshing. I am getting the problem in meshing. Hope you can help with this… Cheers!!

Hello @RicardoParis , Thanks for showing this mistake. It was obviously an error from my side. I have corrected the settings and started the meshing again. Will let you know if this happens again, Thanks again!

Floating Point error in meshing

Project Support

tsite May 4, 2021, 12:59pm 2

Hi there, have you checked the following page regarding this issue?

Best regards,
Fillia