Fatal IO (Input/Output)

Hi,

I am running some Convective Heat Transfer simulations on this project. SimScale

In one of them, which is named “12 D2S 1S”, “An error occurred”.
There are no suggestions in the Event log.

Could you help me with this?

Best regards,
Giannios

Hello Giannios,

I noticed that you had a handful of successful simulations before the failed one (with similar models). What is the difference between the runs, as far as the set up/geometry goes?

Thanks for the reply.

In this one I have added a wall, which is modeled as porous media, as you can see in the screenshot below.

This is the only difference compared to simulation “11 D2S”, which was completed successfully.

Regards