Hi. I have been trying to correspond the simulation process according to the tutorial here. There are some confusions.
In “Forces & Moments” section under ‘Wing’, we see that the image contains the value of Write Interval (simulation time steps) is 50, which has not been mentioned below the image, this puts me in confusion if I’m supposed to let the value be ‘1’ as nothing has been mentioned or shall I enter the value ‘50’ as shown in image?
Again after that, in “Field Calculations” section we see that there is the mention of ‘y-plus’ and ‘Wall Shear Stress’ sections however it doesn’t say anything about the section of ‘Total Pressure’ being there as seen in the image in the next section that is “Surface Data”. This makes me wonder if these are necessary enough to consider and if my errors in simulation run has anything to do with it.
I’ll be gladly waiting for your reply. Thanks in advance.