CFD Floor-cut-out

Project Support
1

Hey Guys,

i need help with a simulation of a floor-cut-out from a building. I am new to simulating in general and also with simscale.
I try to achive a wind-simulation of the cut out floor. So it could look like this:

sim05
sim05981×424 530 KB

But when i try to simulate i get an error everytime and i dont know how to solve this problem.
Would be nice if you guys could help me with that.
Project: SimScale

Thanks in advance

2

Hey @maus_milan,
it looks like your simulation is still running, did you delet the canceled simulations ?

Best regards
Kai

edit:
So the error message is “A multi-region mesh was assigned - this analysis-type requires a single-region mesh.”
I found a topic that describes your simulation problem.

Best regards
Kai

2 Likes