CFD Different Results - Same Setup

Awesome. I will try it as soon as I can.
I really appreciate you helping out with this one.
Fingers crossed!!!

UPDATE:
That worked on a couple of the runs, but wasn’t able to repeat it.
@jairogut were you able to get it to run?

Gauge pressure field started diverging. Please check the mesh quality near the reported location and try refining the mesh. If the problem occured near a boundary, please check the boundary conditions. In case of doubt, please ask for assistance via our support chat.

I actually forgot to change the initial velocity in the setup from 0. It seemed to work pretty well, but I still have some weird high pressures between the vanes.

1 Like

I’m a bit short of time. Can you show me what is a “weird high pressure between the vanes”? Remember the grid in those “thin locations” must be refined accordingly. Also, do remember what I told you about automatic refinement in this “relatively” complex case. Make sure the areas in the wake of a bluff, where low pressures are expected, remain refined.

1 Like

Remember to give an initial y-velocity different from 0, that will help the solver a lot to come out with the solution

1 Like

I really appreciate everyone’s feedback on this.

1 Like