Hello Support Team, I am simulating incompressible flow in safet valve. I have given boundary condition at pressure inlet equal to bar. But the calculation of pressure is not correct. Please help me with this . Thank you

Greetings, Upon reviewing the boundary conditions, it appears that both the inlet and outlet pressure conditions are set at 0 Pa. And the initial pressure condition is set at 1 bar. I wanted to bring to your attention that while there may be a very slight(almost negligible) pressure drop, our post-…

SimScale CAE Forum

Boundary condition for safety relief Valve

Project Support

bbhagat98 December 13, 2023, 10:59am 11

Hi,
Check out the solution on this post SIDEPOD outlet mass flow rate - #2 by tsite