When I strated running simulation it shows ’ An error ocurred ’ Totally no idea what is going on here, everything is fine , mesh, simulation work preparation, checked that and everything previous is good, but always happen this. What should I do can anybody help me? [com-2017-10-28-08-44-36-248]

Hi @czhang ! Please try to open the results again. Should work! Best, Jousef

That’s okay now thank you very much

Hi @czhang ! Will definitely have a look at it later on. Not at home at the moment I hope this is fine though. All the best! Jousef

Think this is different as there is actually a log report: [6] --> FOAM FATAL ERROR: [6] faceSource faceSource300: patch(RadiatorZone_boundingFaces): Unknown patch name: RadiatorZone_boundingFaces. Valid patch names are: 20 ( boundingBox1 boundingBox2 boundingBox3 boundingBox4 boundingBox5 …

Hi @czhang , sorry that wasn’t clear was it :slight_smile: I meant this more as a statement of what has gone wrong, for some reason the volume you selected wasn’t recognised as a selectable patch. Are you using another setup as an example? Kind regards, Darren

OKay thank you and I will try to set another oneand re-simulation it

The only reason why I asked about the setup is that in the docs it only mentions assigning primitives to a porous material, not a cell zone, was just wondering if there was an example you were following that used a cell zone as the region instead? Cheers, Darren

I followed this but without angle wind, [image] Step-by-Step Tutorial Session 3 - Yaw Angle Study (Part 1) Formula Student/SAE Workshop - 2017 Recording [CFD in Formula Student and Formula SAE - Session 3: Aerodynamics Development Strategies] Home…

SimScale CAE Forum

An error ocurred

Project Support

czhang October 29, 2017, 3:25pm 28

Sorry but did not very understand what is this mean