When I strated running simulation it shows ’ An error ocurred ’ Totally no idea what is going on here, everything is fine , mesh, simulation work preparation, checked that and everything previous is good, but always happen this. What should I do can anybody help me? [com-2017-10-28-08-44-36-248]

Hi I just tried that but still failed

Hi @czhang ! Just shared the project with you - tried it an hour ago and worked. Copy it and see if you can re-run another simulations with other parameters just to confirm. Best, Jousef

Just found that it seems the solution fields is still error like this [com-2017-10-28-21-08-44-479]

Hi @czhang ! Please try to open the results again. Should work! Best, Jousef

That’s okay now thank you very much

Think this is different as there is actually a log report: [6] --> FOAM FATAL ERROR: [6] faceSource faceSource300: patch(RadiatorZone_boundingFaces): Unknown patch name: RadiatorZone_boundingFaces. Valid patch names are: 20 ( boundingBox1 boundingBox2 boundingBox3 boundingBox4 boundingBox5 …

Sorry but did not very understand what is this mean

Hi @czhang , sorry that wasn’t clear was it :slight_smile: I meant this more as a statement of what has gone wrong, for some reason the volume you selected wasn’t recognised as a selectable patch. Are you using another setup as an example? Kind regards, Darren

SimScale CAE Forum

An error ocurred

Project Support

jousefm October 29, 2017, 12:47pm 25

Hi @czhang!

Will definitely have a look at it later on. Not at home at the moment I hope this is fine though.

All the best!

Jousef