3d rendering issues after simulation of a rotating turbine


I have issues with a simulation, as I am striving to get a 3d rendering of the air flows of a rotating turbine. Goal being to visualize flows directions ( lines) , velocity in colors and the according data ( efficiency / rotating speed). I could run the simulation but the result is very deceiving. Can you help? I can’t see what is going wrong. Thank you very much.


There’s currently a 0 rad/s rotational speed specified to the rotating zone, thus generating no flow field. Make sure to review the settings and re-run the case.


Dunno how it went away, thought it was there. Thank you so much!

1 Like