Thank you so much for the detailed and quick response! I was able to figure out how to do it and the process opened my eyes to a lot of functions that I wasn’t previously aware of (read: paying attention to) which will certainly save me questions down the line.
One follow-up question I had, is there a way to add a measurement such as this in after the the simulation run has already occurred? Obviously, I will try to put all my measurement points in prior to running the simulation but if I were to forget or otherwise make a mistake would there be a way to add that point/measurement in after the fact without running another simulation?
Here is the link to the project that I am using to learn with: https://www.simscale.com/workbench?publiclink=e7c5f5ef-b25d-4953-8020-44de915b1c03
Thanks again!
Regards,
Kyle