Thanks Igor,
Thanks, I think I understand it slightly better. But…
When I hover over ‘Exit’ I see the text: ‘Exit without applying changes’, but I now understand that this is ‘Exit without applying changes in the SIMULATIONS Geometry leaf and exit CAD mode’.
In some way I don’t want the SIMULATIONS Geometry leaf to be changed as the related Mesh/Run belongs to the used earlier Geometry.
<I saw indeed that the SIMULATIONS Geometry leaf was changed with the edited geometry in CAD mode, which becomes very confusing when looking at the Geometry and the Mesh/Run; at least for me>
And ‘Save as copy’ means ‘Save as a new geometry in GEOMETRIES and exit CAD mode’. But this exiting also does not make changes in the SIMULATIONS Geometry leaf.
So I still don’t fully understand these two options.
Using ‘A workaround for editing different geometries is to upload the original one multiple times, so that each one should be changed on it’s own for the alterations to be applied in CAD mode.’ might indeed be the best.
It looks there is inheritance going on (and perhaps that should be explicit in the GEOMETRIES tree). I will further try/test/digest…
All the best.