Enclosure unable to be created due to cleanup reasons

[cjquijano]

Please check the response in the other thread regarding this topic.

No solid part shown during meshing

Hi @MihirRayganga, I looked at the geometry “body_and_sidepods_v1” and this part does not contain a valid solid so the only geometry imported is surface geometry which Simscale cannot use. [image] I imported the STEP file into Onshape and and it came across with many errors and it would not import as a solid either. Below is an example of one or the problem areas I found. I also see quite a few edges less than .5mm. If this is a valid solid in Fusion 360 you can try to see if you can expor…

Thanks!
Christopher