Hi everyone, I’m trying to create a simulation of a walk-in freezer cold storage for our undergraduate design paper project. It is modeled after a walk-in freezer design (space-wise) that is suitable for our “pretend” client and fits well within their store (we’re not actually doing this in real li…

Hello! The details are very helpful. If you follow the steps outlined in this article , you will notice a small detail in the geometry next to the divergence point. [image] [image] I’d suggest cleaning that up as a starting point. Usually small faces, small gaps and unnecessarily complex topolo…

Hey Ricardo! Thanks for the feedback, I appreciate it and considered it for my new simulation. I tried re-creating the same simulation about what I just asked for on this forum, however, I cannot seem to extract an internal flow volume. I’ve tried using Simscale’e gap tool and found nothing, no ho…

SimScale CAE Forum

Cold Storage Refrigeration (Walk-In Freezer)

Project Support

Ricardopg April 20, 2025, 6:58pm 4

When this message comes up, in 99% of cases there is a hole in the geometry. In your case it’s right here (red highlight).

Cheers