CFD Simulation Mesh of propeller

Project Support
3

Hi jousefm,

I tried two more times:

  1. I build the rotating cylinder around the other wall part. The result is the same, the inner walls will be omitted. Thus, I suppose, the cause for not-meshing is related to the rotating cylinder.
  2. I tried to build the rotating cylinder by using geometry primitives, but this doesn’t work.
  3. I tried to move the origin of the rotating cylinder to the outer wall of the fan surface. Still no meshing.

Regards

Andreas

Additional: I also tried to activate Multi Region Meshing. Then meshing is done properly, but simulation is not running