Set up your own cloud-native simulation in minutes.Start Simulating Now
boiler block 4
23
1
Statistics
2Â Geometries
1Â Mesh
3Â Simulation setups
3Â Results
2Â Geometries 1Â Mesh 3Â Simulation setups 3Â ResultsAbout this project
Update. Made big changes to model. Went with fin design, instead of a pin design. Changed sim set up. Use Velocity in and Pressure out. Does it flow? It is a fluid heat transfer block/water boiler block. The block goes onto heat source, water gets pumped into it, and aim is to heat up the water. To increase the surface area there are lots of fins inside, and fluid needs to turn 180, so the fins at the turn are in a radial pattern. I wanted to simulate the water flow to see what it might do, and see if there are any massive dead spots.
