SimScale simulation projects by rpapa | Page 1

rpapa's profile

The tutorial project is a sample Electronic cooling sink which consists of 3 solid regions and 1 fluid region. The solid regions are two FB-4 chips, which have a higher initial temperature and a heat sink over one of the chips. The air flows over the solid regions to remove the heat from it.

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Accurate and reliable computational fluid dynamics (CFD) simulations are essential for the assessment of
cross-ventilation of buildings.
To determine which CFD models are most suitable, validation studies are required.
Therefore, the objective of this simulation is validate a 3D steady RANS simulation of cross-ventilation using OpenFoam (SimScale)
The validation is based on the velocity parameter
The RANS simulation here is conducted with the realizable k-e turbulence models.
The experimentally observed direction of the incoming jet, but all RANS models fail in
It is concluded that choice of the RANS using SimScale Plataform actually produces good results

This project simulates the reattachment phenomenon over a backward-facing step.

This project simulates Scalar Transport mixing in turbulent T-Junction pipe flow.

The goal of this case study is to validate the Convective Heat Transfer analysis type on the SimScale platform.

Public Profile

rpapa's profile