My goal is to try to make a folding wing that has a flap on it's trailing and leading edge, the winglet will turn into an aileron or a rudder only for precise movements using computers in the aircraft/jet. This will be especially useful for planes like Boeing's 737-8 MAX or 777X (Which even a small movement on the yoke can change the aircrafts direction). The wing will be flushed by using panels and won't create extra drag when in a position (chosen by the pilot) and for safety reasons, when the wing is changing it position, the flaps will be set to position norm and will remain flat until it has turn to it's given position. When these minute movements aren't required (For example cruising), the pilot can set the switch to "off". These flaps will available during takeoff and landing and will allow the pilots to control the plane better. The movements of these flaps are strictly restricted in high speeds due to sudden and harsh changes of direction. Incase of the flaps failing, the system will detect it and retract the winglet to make it vertical, then, using gravity, the panel will slide into position norm and there will be a mechanical latch to confirm if it has slid into position norm (This is still proposed, I am going to test it and see if it works). i will be using computer wind tunnel simulations and AI to help me design 3D models (I am 12 years old and do not know how 3D design). I will try to pitch this idea in an event and change aviation. I do not mind if someone makes improvements on my project (Please give me credit) :) - Rohan Choudhury
by slilbaekslilbaek
Ninjabobyou created this project
My goal is to try to make a folding wing that has a flap on it's trailing and leading edge, the winglet will turn into an aileron or a rudder only for precise movements using computers in the aircraft/jet. This will be especially useful for planes like Boeing's 737-8 MAX or 777X (Which even a small movement on the yoke can change the aircrafts direction). The wing will be flushed by using panels and won't create extra drag when in a position (chosen by the pilot) and for safety reasons, when the wing is changing it position, the flaps will be set to position norm and will remain flat until it has turn to it's given position. When these minute movements aren't required (For example cruising), the pilot can set the switch to "off". These flaps will available during takeoff and landing and will allow the pilots to control the plane better. The movements of these flaps are strictly restricted in high speeds due to sudden and harsh changes of direction. Incase of the flaps failing, the system will detect it and retract the winglet to make it vertical, then, using gravity, the panel will slide into position norm and there will be a mechanical latch to confirm if it has slid into position norm (This is still proposed, I am going to test it and see if it works). i will be using computer wind tunnel simulations and AI to help me design 3D models (I am 12 years old and do not know how 3D design). I will try to pitch this idea in an event and change aviation. I do not mind if someone makes improvements on my project (Please give me credit) :) - Rohan Choudhury