SimScale simulation projects by syedak47 | Page 1

syedak47's profile

Setting up a heat transfer simulation of a cooling plate to determine the resulting temperature and heat flux distribution. Since there are a temperature sensitive IGBT components on one side of the cooling plate it is important that all surfaces of the cooling plate remain below 115 degrees C.

Full car model FSAE Full Car with a radiator using the porous media approach, rotating wheels using the rotating wheel boundary condition, and rotation of the car rims using Multi Reference Frame (MRF). For this case, the front wing flap angle of 0 degrees will be considered and the velocity of the car will be set at a constant 20 m/s.

To investigate the full car model Model-Conf-Yaw. The velocity of the car will be considered constant at 20 m/s with side wind.

Steady-state structural analysis of an aluminum front suspension upright and analyze the results for stress and deformation

The idea is to create a better design than the existing one by creating more downforce with higher efficiency (i.e. can you produce less drag) within the FSAE regulations

The idea is to create a better design than the existing one by creating more downforce with higher efficiency (i.e. can you produce less drag) within the FSAE regulations.

Public Profile

syedak47's profile