SimScale simulation projects by ss_garcia | Page 1

ss_garcia's profile

Simulation as 2.1 but adding some more tubes and changing their diameter from 20 mm to 10 mm. These tubes are separated 80 mm

Cast test simulating an aluminium piece at 650 C and 700 C inside a steel mould as a initial condition. Software simulate the cooling mould in 300s. Due the maximun runtime the maximal end time is 350 s aproximately.

First simulation consisting in a model made of a cube with a cavity representing the mould and the piece. In simscale has been added an enclosure for simulating the air volume. (IN THIS ONE I'VE SIMULATED A WALL HEAT FLUX AND A TABLE DECREASING THE TEMPERATURE. IT MUST BE MODIFYIED BC NOT ALL CONTACTS ARE DETECTED).

Heat transfer test for a simple cast piece

Conjugate heat transfer simulation tutorial.

Computation of the thermal comfort including Local Mean Age of Air and radiation in a meeting room using CFD simulation.

Pedestrian Wind Comfort Analysis for assessing wind speed through the city of Rotterdam

This advanced thermal management tutorial describes the setup and analysis of electronics cooling on an electronics box containing different electronic components being cooled by the airflow of a fan.

This tutorial project aims to showcase how to set up and run a simulation for a pump geometry. The Standard meshing tool was used.

This tutorial contains a thermal comfort project, which analyses the duct positioning inside a theater, in order to have an effective ventilation system.

LED Spotlight project, aiming a bring the temperature of the diodes of a LED spotlight design below the maximum allowed temperature of 100C. A Conjugate Heat Transfer v2.0 analysis is used.

Public Profile

ss_garcia's profile