Set up your own cloud-native simulation in minutes.Start Simulating Now
126
0
1 Geometry
1 Mesh
1 Simulation setup
1 ResultI have tried to find the displacement and von Mises stress of the mounting plate when subjected to a pressure of 1MPa on the cut out section in plate. It is fixed at back with the 4 bolts. The model is generated by me using Creo 2.0 and uploaded as a .stp file.
1 Geometry 1 Mesh 1 Simulation setup 1 ResultI have tried to find the displacement and von Mises stress of the mounting plate when subjected to a pressure of 1MPa on the cut out section in plate. It is fixed at back with the 4 bolts. The model is generated by me using Creo 2.0 and uploaded as a .stp file.
vinugholap created this project
over 10 years ago
smohaimenul_is copied this project
almost 4 years ago
