Set up your own cloud-native simulation in minutes.Start Simulating Now
0
0
1 Geometry
0 Meshes
1 Simulation setup
2 ResultsContext for your Simulation At 4,000 m³/h: You were using 0.65 kg/s (approx). At 1,000 m³/h: You are using 0.34 kg/s. If you decide to run a "low-speed" test to stabilize your CFD, make sure to update your Inlet Boundary Condition in Fluent from your previous value (e.g., 0.65 kg/s) to 0.34 kg/s. Would you like me to: Show you how to update the Mass Flow Inlet boundary condition in Fluent with this new value? Explain how to calculate the required "Turbulence Intensity" at this new, lower mass flow rate? Help you adjust your "Reference Values" in Fluent to match this new flow rate?
sarv123 created this project
14 days ago
1 Geometry 0 Meshes 1 Simulation setup 2 ResultsContext for your Simulation At 4,000 m³/h: You were using 0.65 kg/s (approx). At 1,000 m³/h: You are using 0.34 kg/s. If you decide to run a "low-speed" test to stabilize your CFD, make sure to update your Inlet Boundary Condition in Fluent from your previous value (e.g., 0.65 kg/s) to 0.34 kg/s. Would you like me to: Show you how to update the Mass Flow Inlet boundary condition in Fluent with this new value? Explain how to calculate the required "Turbulence Intensity" at this new, lower mass flow rate? Help you adjust your "Reference Values" in Fluent to match this new flow rate?
by slilbaekslilbaek
