SimScale simulation projects by petercogan | Page 1

petercogan's profile

This project demonstrates the static stress analysis of three aircraft engine bearing bracket models considering both linear and nonlinear material definition. The models used in this analysis are taken from GrabCAD users who were the winners of GrabCAD 'Airplane Bearing Bracket Challenge'. The models are tested with horizontal and vertical loading conditions as provided on the challenge page of GrabCAD.

The project simulates 2 cases of aircraft wings to compare the aerodynamic effects.

This project simulates the free movement of floating boat under a wave using 6 DOF motion.

This project involves the simulation of stress analysis of an aircraft wing. There are total 6 comparison configurations with 3 different models and two different load definition.

This project involves the simulation of ventilation in an aircraft cabin. There are 6 comparison configurations with 3 different inlets and 2 outlets.

This project simulates air flow around an Aircraft at low sub-sonic compressible flow regime.

FSAE-Workshop Session-3 Homework project for aerodynamics of full car

This project demonstrates the usage of rotating zones

FSAE-Workshop Session-2 Homework project for aerodynamics of complete Formula Student Race Car

This project simulates transient wake formation behind a boat.

FSAE workshop session 1-Front Wing Analysis homework tutorial project.
For Step-By-Step see: https://www.simscale.com/forum/t/step-by-step-tutorial-homework-of-session-1/52675

Public Profile

petercogan's profile