SimScale simulation projects by ofadodun | Page 1

ofadodun's profile

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

to simulate heat conduction in a plane surface

Webinar Project- Carotid Artery Bifurcation
The project simulates the flow of blood as a non-newtonian fluid through a realistic Carotid Artery Bifurcation. Simulation are performed for 3 cases- of a healthy blood vessel  with no calcification or blockage and through an moderately and severely calcified or blocked blood vessel. 
The results show the differences in pressure, velocity profile and the outlet flow  through the 2 branches.

Flow conditions are based on a paper: STUDY OF BLOOD FLOW IN A BIFURCATION WITH A STENOSIS,
Sonia I.S. Pinto, E.D. Costa, J.B.L.M. Campos, J.M. Miranda

Related to step-by-step tutorial of the biomedical workshop (session 1)

https://www.simscale.com/forum/t/biomedical-engineering-workshop-session-1-stress-shielding-in-a-hip-joint-prosthesis/36830/3

Tutorial project for a thermal analysis of a differential casing. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

FEA Master Class Session 3 handout: In this project the drop test of an iPhone 6 has been performed with and without case.

This meshing tutorial shows how to setup the Tetrahedral automatic, Tetrahedral parametric and the Tetrahedral with local refinements for a structural analysis simulation.

In this exercise, you will complete a laminar pipe flow analysis

Related to step-by-step tutorial of the biomedical workshop (session 2) https://www.simscale.com/forum/t/biomedical-engineering-workshop-session-2-analysis-of-cardiovascular-stent/36862

the project is about studying the effect of attack angle on aerodynamic

This project contains the geometry of the extruder for the first homework assignment of the 3D Printing workshop.

Public Profile

ofadodun's profile