How Leaders are Escaping AI Pilot PurgatoryRegister here
Reference Pitot Tube Geometries for Pitot Modeling Project
383
2
Statistics
4 Geometries
2 Meshes
2 Simulation setups
2 Results
4 Geometries 2 Meshes 2 Simulation setups 2 ResultsAbout this project
I have uploaded 2 geometries of Pitot Tubes with blockages. These are expamples of the geometries we will use, and show how we will vary the geometries between differente iterations. 90 percent blocked with 5 mm protrusion is a more advanced geometry (we would like to go up to 99 percent) and 50 percent blocked 1mm is a more reduced blockage. the blockage percentage is determined as the ratio of inlet area vs blocked area (in our case a circle with 90 percent surface are as inlet area). Protrusion is the length this blockage extends past the static port entrance.
