SimScale simulation projects by mlarreta | Page 1

mlarreta's profile

Homework for drone workshop session no. 2

Evaluate different types of snap joint: Cantilever, U-Shaped, Torsional and Annular

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

A turbulent flow simulation of a ball valve is demonstrated in this project.

In this project, thermostructural analysis of two different designs of spark plug were performed

Project for Heat transfer in a heat-sink and stresses in a PCB

This is a comparison between the results of Simscale and the hand calculus for a simple beam

The effect of numerics on the simulation quality and convergence time.

This project demonstrates the usage of rotating zones

In this project vibration analysis of jet engine is performed.

The project simulates 2 cases of aircraft wings to compare the aerodynamic effects.

This project simulates air flow around an Aircraft at low sub-sonic compressible flow regime.

Structural simulation for Human Powered Vehicle Competition of ITT college students

This project shows the sliding of a rubber seal on a rigid body due to applied displacement.

A contact analysis of a consumer snap fit mechanism is analyzed in this project.

This project involves the simulation of stress analysis of an aircraft wing. There are total 6 comparison configurations with 3 different models and two different load definition.

This project involves the simulation of ventilation in an aircraft cabin. There are 6 comparison configurations with 3 different inlets and 2 outlets.

Tutorial project for linear static analysis of a crane

This project demonstrates the static stress analysis of three aircraft engine bearing bracket models considering both linear and nonlinear material definition. The models used in this analysis are taken from GrabCAD users who were the winners of GrabCAD 'Airplane Bearing Bracket Challenge'. The models are tested with horizontal and vertical loading conditions as provided on the challenge page of GrabCAD.

Static Linear and Nonlinear Analysis of a truck underrun protection

CFD Professional Training Exercise 4-Tank filling multi-phase

Simulation to select the best SMT method of two different IC's

Compare between the original design and the built design.

Public Profile

mlarreta's profile