SimScale simulation projects by matt_t | Page 1

matt_t's profile

F1 Front Wing Geometry for Frontwing Tutorial

Tutorial project for setting up the Automated Hex-dominant for internal flow for an angled pipe geometry.

This project aims to showcase the different configuration options for the standard meshing tool, including basic and advanced settings. The various refinements are also covered.

Empty project containing the geometry of an engine piston for the thermomechanical tutorial of an engine piston

Thermal Analysis of a Differential Casing

This advanced thermal management tutorial describes the setup and analysis of electronics cooling on an electronics box containing different electronic components being cooled by the airflow of a fan.

LED Spotlight project, aiming a bring the temperature of the diodes of a LED spotlight design below the maximum allowed temperature of 100C. A Conjugate Heat Transfer v2.0 analysis is used.

In this tutorial, the transport of exhaust gases into the atmosphere is simulated. Gases will come out of two chimneys of a plant.

This tutorial contains a thermal comfort project, which analyses the duct positioning inside a theater, in order to have an effective ventilation system.

Computation of the thermal comfort including Local Mean Age of Air and radiation in a meeting room using CFD simulation.

This tutorial project aims to showcase how to set up and run a simulation for a pump geometry. The Standard meshing tool was used.

This projects aims to showcase the function of a golf ball's dimples, compared to a same ball of smooth surface.

This tutorial aims to showcase how to set up a compressible analysis. An aircraft wing geometry is used.

Tutorial on incompressible flow simulation for aerodynamics studies, using SimScale Standard mesh algorighm.

Stress analysis of plexiglass coffee table top.  With different forces and application areas.

Drone propeller flow analysis simulation using MRF model and SimScale standard mesher.

Study of CO contamination inside a car park

Conjugate heat transfer simulation tutorial.

Analysis of plexiglass tabletop on a rigid frame.  Modeled using contacts.

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Tutorial showing the workflow for nonlinear FEA structural analysis, including varying load, hyperelastic material and elastic support.

This project shows the bending of an Aluminium pipe through rolling process.

IA crash test tutorial for a dynamic simulation of an FSAE Impact Attenuator.

Tutorial project for linear static analysis of a crane

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

matt_t's profile