Explore agentic engineering workflow on SimScaleExperience Engineering AI
0
0
Statistics
2Â Geometries
1Â Mesh
1Â Simulation setup
2Â Results
2Â Geometries 1Â Mesh 1Â Simulation setup 2Â ResultsAbout this project
Update Sim run1 was set up as Pressure inlet + Pressure outlet. I was told that this 'boundary condition combination is very poor in terms of stability'. I don't think the data is any good? Sim run2 was set up as velocity inlet + pressure outlet. I was told this was better and should stop any diverging. Does it flow? It is a fluid heat transfer block/water boiler block. The block goes onto heat source, water gets pumped into it, and aim is to heat up the water. To increase the surface area there are lots of fins inside, and fluid needs to turn 180, so the fins at the turn are in a radial pattern. I wanted to simulate the water flow to see what it might do, and see if there are any massive dead spots. Seems like there is a lot of interesting things going on. - Copy
