SimScale simulation projects by kebben | Page 1

kebben's profile

heat transfer through a desorption medium

Tutorial project for setting up the Automated Hex-dominant for internal flow for an angled pipe geometry.

This meshing tutorial shows how to setup the Tetrahedral automatic, Tetrahedral parametric and the Tetrahedral with local refinements for a structural analysis simulation.




The tutorial project is a sample Electronic cooling sink which consists of 3 solid regions and 1 fluid region. The solid regions are two FB-4 chips, which have a higher initial temperature and a heat sink over one of the chips. The air flows over the solid regions to remove the heat from it.

Forced Convective Heat Transfer - Raspberry Pi

Tutorial project for a thermal analysis of a differential casing. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

kebben's profile