SimScale simulation projects by julien_venture | Page 1

julien_venture's profile

Sample project for how to set-up the Hex-Dominant Parametric mesh for flow around a vehicle body.

Exercise 1: Stress Analysis of a Formula Student Front Upright

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Test de différentes sections de poutre en flexion

This project demonstrates the static stress analysis of three aircraft engine bearing bracket models considering both linear and nonlinear material definition. The models used in this analysis are taken from GrabCAD users who were the winners of GrabCAD 'Airplane Bearing Bracket Challenge'. The models are tested with horizontal and vertical loading conditions as provided on the challenge page of GrabCAD.

FEA Master Class Session 3 handout: In this project the drop test of an iPhone 6 has been performed with and without case.

This project involves the simulation of ventilation in an aircraft cabin. There are 6 comparison configurations with 3 different inlets and 2 outlets.

This project involves the simulation of stress analysis of an aircraft wing. There are total 6 comparison configurations with 3 different models and two different load definition.

Tutorial for Static stress analysis of Underrun protection device

Tutorial project for linear static analysis of a crane

Incompressible Fluid Flow analysis of two globe valves

In this exercise, you will perform a simple heat transfer analysis on the SimScale Platform and then compare the results to a hand-calculated solution.

This project simulates air flow around an Aircraft at low sub-sonic compressible flow regime.

Exercise 1: Aerodynamics of a Radio-Controlled Plane

Exercise 2: Heat Transfer of a Cooling Plate

In this exercise, you will use linear static analysis to analyze several configurations of an aircraft engine bracket under a vertical load.

In this exercise, we will consider the deflection of a cantilever beam with a concentrated load at the free end. We can calculate the deflection by hand and via a static analysis using the SimScale platform.

In this exercise, you will complete a laminar pipe flow analysis

Public Profile

julien_venture's profile