Set up your own cloud-native simulation in minutes.Start Simulating Now
0
0
1 Geometry
1 Mesh
1 Simulation setup
2 ResultsSimulate turbulent mixed convection flow in three-dimensional air filled cubical enclosure shown in below figure. Consider H=W=D= 1 m, the left wall of the enclosure has a heater of size 0.2 H mounted centrally and has an forced inlet opening on the left wall and outlet port on the right wall. Both the inlet and outlet port are of same dimensions 0.2 m x 0.1 m. Ambient air at a velocity of 1 m/s and temperature 20OC enters through the forced inlet port and leaves through the outlet port (specify suitable boundary condition at the outlet port). Consider the heater temperature as 100OC. Assuming the flow as steady, incompressible turbulent flow, active LES turbulence model and plot the pressure, velocity contours and temperature contours.
j23bmv1070 created this project
4 days ago
1 Geometry 1 Mesh 1 Simulation setup 2 ResultsSimulate turbulent mixed convection flow in three-dimensional air filled cubical enclosure shown in below figure. Consider H=W=D= 1 m, the left wall of the enclosure has a heater of size 0.2 H mounted centrally and has an forced inlet opening on the left wall and outlet port on the right wall. Both the inlet and outlet port are of same dimensions 0.2 m x 0.1 m. Ambient air at a velocity of 1 m/s and temperature 20OC enters through the forced inlet port and leaves through the outlet port (specify suitable boundary condition at the outlet port). Consider the heater temperature as 100OC. Assuming the flow as steady, incompressible turbulent flow, active LES turbulence model and plot the pressure, velocity contours and temperature contours.
