SimScale simulation projects by geodave | Page 1

geodave's profile

Offset top of Manifold inward 8mm to conserve space

made outer pipes lay on top of each other to conserve space

cleared some obstructions in duct work I didn't see at 1st.

Added squished Nozzle at correct down angle

Transition manifolds to split 8 intakes to 4 intakes

8 direct pipes to nozzles for cooling 3d print

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Made the partial torus tube smaller to help get more air out maybe

Refined where the bumps & curved the ends better

made middle hole ellipitcal & added bump at each end

Made diameter 8mm wider & added nozzles ot end of openings

Changed angle from 218 to 284 degree horseshoe

Test the flow of air from a Fan cooler mounted to Titan Extruder

Public Profile

geodave's profile